For Pitts, the reasoning behind adding CNC to his extensive workshop was a practical business decision. “I view the Desktop as just another tool in my shop, and it’s perfect for certain tasks that make my work easier. One of the ways that I make use of the Desktop is to make small items — that I traditionally only hand-carved — a more efficient process.”
Among the many offerings that are displayed on Pitts’ website, are small customizable plaques, many of which sell for less than $100. “Quite frankly, the carving with the Desktop is wonderfully precise, and its efficiency enables me to make more plaques quickly,” says Pitts. “These plaques are conversation-starters with my customers. If I can interest someone in visiting my shop to discuss a $49 plaque, then that opens the door for me to give a tour, show my larger pieces, and who knows, end up talking about a commission for a $4900 credenza.”
Here’s one of those $49 plaques, made of cherry wood.
Pitts’ prior career was in the Navy as a nuclear engineer, and he says that the Navy unexpectedly prepared him for success as a designer. Pitts explains, “The discipline necessary to command three warships over the course of my career, and operate aircraft carrier nuclear reactors, translated into an astute attention to detail and pursuit of perfection in my wood work.” Inspired by his time of service, Pitts designs and crafts many service-related pieces:
Andy Pitts explains that the precision afforded by the ShopBot Desktop enables the construction of the drawer openings and other openings that you see on this Officer’s Sea Chest. “Precision is astounding,” Pitts remarks. “I visit the ShopBot Forum quite a bit for tips, and have found people talking about using 1/64-inch ballnose bits on the Desktop. It’s quite remarkable what this tool allows you to accomplish.”
Here are some of the furniture pieces that Andy Pitts designs and makes:
The ShopBot Desktop is likely the smallest tool in Andy Pitts’ “arsenal” of woodworking tools, especially when you consider that he has even milled his own lumber — with enough wood to last for many years of projects. Here are photos of his lumber sawmill, which he recently sold, and his solar lumber kiln:
A committed steward of the environment, Pitts uses pre-fallen hardwoods local to the studio, harvesting, milling and drying them himself. Pitts explained that he “wants to celebrate the wood’s inherent beauty, respecting its imperfections and variations. I use only clear finishes, avoiding stains that might mask the grain.” One can recognize a Pitts design by the grace of its curves, exquisitely matched grain patterns, exacting joinery and meticulous finishing…
Pitts says he was heartened to see some very well known furniture makers in attendance at the Furniture Society conference in Washington State who have adopted CNC for precision carving. “I think we’re starting to turn a corner, where more and more furniture makers who consider themselves to be artists are unafraid to integrate CNC into their processes.”
Andy has a very full library of YouTube videos in which he shares his work process; they’re not “how to” videos but rather allow you to watch as he works. Here’s just one of them, in which he gets going on one of his first projects on his ShopBot Desktop. Andy says that the YouTube channel has been very helpful in spreading the word about this work.